12
PEM-X1
OPERATING MANUAL
VERSION 09/2012 ORDER NUMBER DOC 2326020
4.2.1 SAFE HANDLING OF WAGNER POWDER SPRAY DEVICES
4.2.2 GROUNDING THE DEVICE
4.2.3 MATERIAL HOSES
4.2 SAFETY INSTRUCTIONS FOR STAFF
Only use original Wagner powder hose.
Always follow the information in these instructions, particularly the general safety
instructions and the warning instructions.
Always follow local regulations concerning occupational safety and accident
prevention.
Under no circumstances may people with pacemakers enter the area where the
high-voltage eld between the spray gun and the work piece to be coated builds up!
Do not point spray guns at people.
Before all work on the device, in the event of work interruptions and malfunctions:
- Switch o the energy/compressed air supply.
- Lock spray guns against actuation.
- Relieve pressure on spray guns and device.
- In the event of malfunctions: Identify and correct the problem, proceed as
described in chapter "Elimination of Faults".
The electrostatic charge may, in certain cases, give rise to electrostatic charges on the
device. In the event of discharge, this may result in the formation of sparks or ames.
Ensure that the device is grounded before each coating process.
Ground the work pieces to be coated.
Ensure that all persons inside the working area are grounded, e.g. by wearing
electrostatically conductive shoes.
The function of grounding cables must be checked regularly (see EN 60204).
To Next Page
Loading...
Need help?
General
