33
PEM-X1
OPERATING MANUAL
VERSION 09/2012 ORDER NUMBER DOC 2326020
8 CLEANING AND MAINTENANCE
Cleaning work should be undertaken regularly and carefully by quali ed and trained sta .
The sta must be familiar with the DIN EN 50050-2 and DIN EN 50177 provisions. They
should be informed of speci c hazards during their training.
The following hazards may arise during cleaning work:
Health hazard from inhaling powder paint
Use of unsuitable cleaning tools and aids
8.1 CLEANING
8.1.2 SAFETY INSTRUCTIONS
8.1.1 CLEANING STAFF
Explosive powder/air mixes!
Danger to life and equipment damage.
Before starting cleaning or any other manual work, the
high-voltage must be shut down and locked to prevent it from
being switched back on!
The spray gun must be separated from the high-voltage supply
before any cleaning work is started!
Use only electrically conductive containers for cleaning liquids!
Ground the containers!
Preference should be given to non- ammable cleaning uids.
Flammable cleaning uids may only be used if, once the
high-voltage has been switched o and all parts carrying
high-voltage are discharged to a discharge energy of less than
0,24 mJ before they can be accessed.
Most ammable solvents have a ring power of around 24 mJ or
60 nC.
The cleaning agent's ash point must be at least 15 K above the
ambient temperature.
Only mobile industrial vacuum cleaners of construction type 1
(see EN 60335-2) may be used to remove dust deposits.
DANGER
To Next Page
Loading...
Need help?
General
