13
PEM-X1
OPERATING MANUAL
VERSION 09/2012 ORDER NUMBER DOC 2326020
4.2.5 HANDLING POWDER PAINTS
4.2.4 CLEANING
Before starting cleaning or any other manual work, the high-voltage in the spray area
must be shut down and locked to prevent it from being switched back on!
Lock the supply of compressed air and decompress system.
Secure the device against being switched back on without authorization.
Use only electrically conducting and grounded containers for cleaning liquids.
Preference should be given to non- ammable cleaning uids.
Flammable cleaning uids may only be used if, once the high-voltage has been
switched o , all parts carrying high-voltage are discharged to a discharge energy of
less than 0,24 mJ before they can be reached.
Most ammable solvents have a ring power of around 24 mJ or 60 nC.
The cleaning agent's ash point must be at least 15 K above the ambient temperature.
Only mobile industrial vacuum cleaners of design 1 (see EN 60335-2) may be used to
remove dust deposits.
Take note of the processing regulations laid down by the manufacturer of the powder
paint being used, when preparing or processing the powder.
Take note of the manufacturer’s noti cation and the relevant environmental protection
regulations when disposing of powder paints.
Take the prescribed safety measures, in particular wear of safety glasses and safety
clothing and use protective hand cream if required.
Use a mask or breathing apparatus if necessary.
To ensure su cient protection of health and the environment, only operate the device
in a powder booth or at a spray wall with activated ventilation (exhaust air).
To Next Page
Loading...
Need help?
General
