20
PEM-X1
OPERATING MANUAL
VERSION 09/2012 ORDER NUMBER DOC 2326020
6 ASSEMBLY AND COMMISSIONING
6.1 QUALIFICATION OF THE ASSEMBLY/COMMISSIONING STAFF
Incorrect installation/operation!
Risk of injury and damage to the equipment.
The commissioning sta must have the technical skills to safely
undertake commissioning.
The commissioning sta must be familiar with the provisions of
European standards DIN EN 50050-2 and DIN EN 50177.
When putting into operation and for all work, read and follow
the operating instructions and safety regulations for the
additionally required system components.
WARNING
6.2 STORAGE CONDITIONS
Until the point of installation, the powder coating gun must be stored in a dry location,
free from vibrations and with a minimum of dust. The powder coating gun must be stored
in closed rooms.
The air temperature at the storage location must be between 5 - 45 °C; 41 - 113 °F.
The relative air humidity at the storage location must not exceed 75%.
6.3 INSTALLATION CONDITIONS
The air temperature at the installation site must be between 5 - 45 °C; 41 - 113 °F.
Depending on the powder paint used, the maximum permissible ambient temperature for
reliable operation can be signi cantly below +40 °C; 104 °F.
The relative air humidity at the storage location must not exceed 75%.
To Next Page
Loading...
