WAGO I/O SYSTEM 750 XTR Notes about this Documentation 15
750-8202/040-000 PFC200 2ETH RS XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
1 Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1 Validity of this Documentation
This documentation is only applicable to the “PFC200 2ETH RS XTR” controller
(750-8202/040-000).
This documentation is only applicable from FW Version 03.01.07(13).
The device PFC200 2ETH RS XTR 750-8202/040-000 shall only be installed and
operated according to the instructions in this manual and the system description
for the WAGO I/O SYSTEM 750 XTR.
Consider power layout of the WAGO I/O SYSTEM 750 XTR!
In addition to these operating instructions, you will also need the system
description “Design Notes /XTR – Guidelines and Recommendations for
Increasing Operational Safety”, which can be downloaded at www.wago.com
.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2 Copyright
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.
Non-observance will involve the right to assert damage claims.
To Next Page
Loading...
Need help?
General
