WAGO PFC200 2ETH RS XTR User Manual

WAGO I/O SYSTEM 750 XTR Commissioning 169
750-8202/040-000 PFC200 2ETH RS XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
7.8.1.31 “Modbus Services Configuration” Page
The settings for various Modbus services are shown on the “Modbus Services
Configuration” page. The groups are only visible if the e!RUNTIME system is
enabled. Otherwise an information text is displayed.
7.8.1.31.1 “Modbus TCP” Group
Table 103: WBM “Modbus Services Configuration” Page – “Modbus TCP” Group
Parameter
Explanation
Service active
Disable or enable the Modbus/TCP service here.
Click the [Submit] button to apply the changes. The change is effective
immediately.
7.8.1.31.2 “Modbus UDP” Group
Table 104: WBM “Modbus Configuration Services” Page – “Modbus UDP” Group
Parameter
Explanation
Service active
Disable/enable the Modbus-UDP service here.
Click the [Submit] button to apply the changes. The change is effective
immediately.

WAGO PFC200 2ETH RS XTR Specifications

General

Processor	ARM Cortex-A8
Clock Speed	600 MHz
RAM	256 MB
Ethernet Ports	2
Protection Class	IP20
Power Supply	24 V DC
Serial Ports	1 (RS-232/RS-485)
Operating Temperature	-40°C to +70°C
Programming Languages	IEC 61131-3
Certifications	UL