Need help?Do you have a question about the WAGO PFC100 and is the answer not in the manual?
General| Model | PFC100 |
|---|---|
| Processor | ARM Cortex-A8 |
| RAM | 256 MB |
| Operating System | Linux |
| CAN | 1 x CAN |
| USB Ports | 2 x USB 2.0 |
| SD Card Slot | Yes |
| Power Supply | 24 V DC |
| Programming Languages | C, C++ |
| Ethernet | 2 x 10/100 Mbps |
| Serial Interface | 1 x RS232/RS485 |
| Operating Temperature | -25 to +60 °C |
| Weight | 0.5 kg |
Provides essential safety precautions for installation and operation of the device.
Details the various connectors on the controller, including data contacts, service, and network interfaces.
Describes the address selection switch, mode selector, and reset button functions.
Provides detailed technical specifications including mechanical, system, power, clock, and programming data.
Covers network configuration, interface settings, and security for Ethernet connections.
Explains how to use and manage the memory card for storage and backup.
Details carrier rail properties and guidelines for mounting system components.
Provides instructions on the correct sequence for mounting modules onto a carrier rail.
Guides on how to safely insert devices, specifically the controller, onto the carrier rail.
Details the procedure for connecting conductors to WAGO CAGE CLAMP® connections.
Explains the power supply concept, including overcurrent protection and supplementary regulations.
Guides on configuring IP addresses for the controller's Ethernet interfaces.
Provides instructions for changing default passwords to enhance system security.
Outlines methods for configuring the controller via WBM, CBM, CODESYS, and WAGO Ethernet Settings.
Explains how fault/error diagnostics are displayed using cyclic flashing sequences.
Details procedures for upgrading or downgrading controller firmware and performing a factory reset.
Outlines special notes and general installation regulations, including explosion protection.
To Next Page
