148 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.32.3 “Settings” Group
The parameters indicated depend on the cloud platform setting and, if applicable,
on other settings in this group.
Table 89: WBM “Configuration of Cloud Connectivity” Page – “Settings” Group
You can enable/disable the cloud connectivity
function here.
Select the cloud platform here.
Enter the host name or IP address for the selected
cloud platform here.
Here you can specify the group in which the edge
node ID should be placed.
Enter the device ID for the selected cloud platform
here.
Enter the client ID for the selected cloud platform
here.
Enter the edge node ID for the selected cloud
platform here.
Enter the activation key for the selected cloud
platform here.
Here you can specify whether clean session should
be enabled during the connection to the cloud
service. If clean session is enabled, the information
and messages on this connection are not stored
persistently on the cloud service.
Here you can specify whether TLS encryption
should be used for the connection to the cloud
platform.
Amazon Web Services (AWS) always uses TLS.
Enter the port here to which a connection is to be
established.
Typical values are 8883 for encrypted connections
and 1883 for unencrypted connections.
Enter the path here to the file encoded in PEM
format that contains the trusted CA certificate to use
to establish an encrypted connection. The default
value is the CA certificate /etc/ssl/certs/ca-
certificates.crt, which is already installed on the
PFC.
Enter the user name for cloud service authentication
here.
Enter the password for cloud service authentication
here.
Enter the path here to the file encoded in PEM
format that is used for cloud service authentication.
To Next Page
Loading...
Need help?
General
