WAGO PFC100 User Manual

202 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.11.5 “Ports and Services” > “HTTPS” Submenu
This submenu contains the settings for the HTTPS service.
Table 159: “Ports and Services” > “HTTPS” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. State
Enable/disable the HTTPS service.
0. Back to …
Back to the higher-level menu
1. Enable
The HTTPS service is enabled.
2. Disable
The HTTPS service is disabled.
2. Firewall status
Opens a submenu with firewall settings for the this
service for the interfaces
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.2.11.6 “Ports and Services” > “NTP” Submenu
This submenu contains the settings for the NTP service.
Table 160: “Ports and Services” > “NTP” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. State
Enable/disable the NTP service.
0. Back to …
Back to the higher-level menu
1. Enable
The NTP service is enabled.
2. Disable
The NTP service is disabled.
2. Port
Enter the port number of the NTP server.
3. Time Server 1
Enter here the IP addresses of up to 4 time servers.
Time server No. 1 is requested first of all. If no data
can be accessed via time server No. 1, time server
No. 2 is requested.
4. Time Server 2
5. Time Server 3
6. Time Server 4
7. Update Time
Specify here the update interval of the time server.
8. Issue immediate update
To update the time immediately, irrespective of the
update interval, select this menu item.
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English