WAGO PFC100 - HTTP Group; HTTPS Group; WAGO-I;O-CHECK Group; Table 74: WBM Configuration of Network Services Page - HTTP Group

138 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.24.4 “HTTP” Group
Table 74: WBM “Configuration of Network Services” Page – “HTTP” Group
Parameter
Explanation
Service active
Enable/disable the HTTP service here.
Click the [Submit] button to apply the changes. The change takes effect
immediately.
Disconnection abort on disabling
If the HTTP service is disabled, the connection to the controller may be
interrupted. Then open the WBM page again.
7.8.1.24.5 “HTTPS” Group
Table 75: WBM “Configuration of Network Services” Page – “HTTPS” Group
Parameter
Explanation
Service active
Enable/disable the HTTPS service here.
Click the [Submit] button to apply the changes. The change takes effect
immediately.
Disconnection abort on disabling
If the HTTPS service is disabled, the connection to the controller may be
interrupted. Then open the WBM page again.
7.8.1.24.6 “WAGO-I/O-CHECK” Group
Table 76: WBM “Configuration of Network Services” Page – “I/O-CHECK“ Group
Parameter
Explanation
Service active
Enable/disable the WAGO-I/O-CHECK service here.
Click the [Submit] button to apply the changes. The change takes effect
immediately.