212 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.12.4 “SNMP” > “SNMP v3 Configuration” Submenu
This submenu contains settings for SNMP v3.
Opens a series of submenus to create a new v3
user
You can enter 10 users.
The following entries/selections are possible:
• Authentication name (The name can have a
min. 8 and max. 32 characters and may contain
lower case letters (a … z), upper case letters
(A … Z), numbers (0 … 9), special characters
!()*~'.-_ but no spaces.)
• Authentication type (None/MD5/SHA)
• Authentication key (The key can have a min. 8
and max. 32 characters and may contain lower
case letters (a … z), upper case letters (A … Z),
numbers (0 … 9), special characters !()*~'.-_ but
no spaces.)
• Privacy type (None/DES/AES)
• Privacy key (The key can have a min. 8 and
max. 32 characters and may contain lower case
letters (a … z), upper case letters (A … Z),
numbers (0 … 9), special characters !()*~'.-_ but
no spaces.)
• IP address for a trap receiver for v3 traps
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.