WAGO PFC100 - Configuration of DNS Service Page; DNS Service Group; Table 84: WBM Configuration of DNS Service Page - DNS Service Group

WAGO-I/O-SYSTEM 750 Commissioning 145
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.30 “Configuration of DNS Service” Page
The settings for the DNS service are shown on the “Configuration of DNS
Service” page.
7.8.1.30.1 “DNS Service” Group
Table 84: WBM “Configuration of DNS Service” Page – “DNS Service” Group
Parameter
Explanation
Service active
You can enable/disable the DNS server service
here.
Mode
Select here the operating mode of the DNS server:
Proxy
Requests are buffered to optimize
throughput.
Relay
All requests are routed directly.
Static hosts
This displays the static assignments of IP addresses
to names. If no assignment was defined, “No static
hosts configured” is displayed.
New static host
Enter here a new static assignment, e.g.,
“192.168.1.20:hostname.”
You can enter 10 assignments.
Click on [Submit] to accept the changes. The changes will be effective
immediately.
Click on [Add] to accept a new assignment. The change is effective immediately.
Click on [Delete] to delete an existing assignment. The change is effective
immediately.