WAGO-I/O-SYSTEM 750 Use in Hazardous Environments 259
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
14 Use in Hazardous Environments
The WAGO I/O SYSTEM 750 (electrical equipment) is designed for use in Zone
2 hazardous areas and shall be used in accordance with the marking and
installation regulations.
The following sections include both the general identification of components
(devices) and the installation regulations to be observed. The individual
subsections of the “Installation Regulations” section must be taken into account if
the I/O module has the required approval or is subject to the range of application
of the ATEX directive.
To Next Page
Loading...
Need help?
General
