WAGO PFC100 - Meaning of Blink Codes and Procedures for Troubleshooting; Table 188: Overview of Error Codes, I;O LED

WAGO-I/O-SYSTEM 750 Diagnostics 243
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
10.2.3 Meaning of Blink Codes and Procedures for
Troubleshooting
This section describes the diagnostics presented as blink codes via the I/O LEDs.
If the diagnostics cannot be cleared by the measured specified for them, contact
WAGO support. Be ready to explain to them the blink code that is displayed.
Phone: +49 571 887 44 55 5
Fax: +49 571 887 84 45 55
E-mail: support@wago.com
Table 188: Overview of Error Codes, I/O LED
Error code
Explanation
1
Hardware and configuration error
2
Configuration error
3
Local bus protocol error
4
Physical error on the local bus
5
Local bus initialization error
6
Not used
7
Not supported I/O module
8
Not used
9
CPU exception error