WAGO PFC100 User Manual

WAGO-I/O-SYSTEM 750 Commissioning 209
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.11.17 “Ports and Services” > “PLC Runtime Services” Submenu
This submenu contains the settings for the PLC runtime system services.
Table 171: “Ports and Services” > “PLC Runtime Services” Submenu
Menu Item
Explanation
0. Back to …
Back to the higher-level menu
1. General Configuration
Enter the password for port authentication.
2. e!RUNTIME
Opens a submenu with service settings for
e!RUNTIME
3. Change CODESYS
Runtime firewalling
settings
Opens a submenu with firewall settings for the this
service for the interfaces
4. Change CODESYS
WebVisu firewalling
settings
Opens a submenu with firewall settings for the this
service for the interfaces
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
7.8.2.11.18 “PLC Runtime Services” > “e!RUNTIME” Submenu
This submenu contains the settings for the e!RUNTIME service.
Table 172: “Ports and Services” > “PLC Runtime Services” > “e!RUNTIME” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. Webserver
enable/disable
Enable or disable the Webserver for the
e!RUNTIME web visualization.
0. Back to …
Back to the higher-level menu
1. Enable
The Webserver is enabled.
2. Disable
The Webserver is disabled.
2. Port Authentication
enable/disable
Enter here whether a login is required for connecting
to the device.
0. Back to …
Back to the higher-level menu
1. Enable
Authentication via login is required.
2. Disable
Authentication is not required.
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English