WAGO PFC100 - General Configuration > PLC Runtime Version Submenu; PLC Runtime > General Configuration Submenu; Table 115: PLC Runtime > General Configuration Submenu; Table 116: PLC Runtime > General Configuration > PLC Runtime Version

172 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.3.3 “PLC Runtime” > “General Configuration” Submenu
This submenu contains other submenus with general settings for the runtime
system.
Table 115: “PLC Runtime” > “General Configuration” Submenu
Menu Item
Explanation
0. Back to …
Back to the higher-level menu
1. PLC Runtime Version
Opens a submenu for the CODESYS runtime
system settings
2. Home Dir On SD Card
Opens a submenu for the home directory settings
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.2.3.4 “General Configuration” > “PLC Runtime Version” Submenu
In this submenu, select which PLC runtime system is enabled.
Table 116: “PLC Runtime” > “General Configuration” > “PLC Runtime Version” Submenu
Menu Item
Explanation
0. Back to …
Back to the higher-level menu
1. None
No runtime system is enabled.
2. e!RUNTIME
The e!RUNTIME runtime system is enabled.
All data is deleted when switching the runtime system!
The runtime system’s home directory is completely deleted when switching the
runtime system!
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].