WAGO PFC100 - Ports and Services > IOCHECK PORT Submenu; Ports and Services > Modbus TCP Submenu; Table 166: Ports and Services > IOCHECK PORT Submenu; Table 167: Ports and Services > Modbus TCP Submenu

206 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.11.12 “Ports and Services” > “IOCHECK PORT” Submenu
This submenu contains settings for the WAGO-I/O-CHECK port.
Table 166: “Ports and Services” > “IOCHECK PORT” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. State
Enable/disable the WAGO-I/O-CHECK port.
0. Back to …
Back to the higher-level menu
1. Enable
The WAGO-I/O-CHECK port is
enabled.
2. Disable
The WAGO-I/O-CHECK port is
disabled.
2. Firewall status
Opens a submenu with firewall settings for the this
service for the interfaces
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.2.11.13 “Ports and Services” > “Modbus TCP” Submenu
This submenu contains the settings for the Modbus TCP service.
Table 167: “Ports and Services” > “Modbus TCP” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. State
Disable or enable the Modbus/TCP service.
0. Back to …
Back to the higher-level menu
1. Enable
The Modbus TCP service is enabled.
2. Disable
The Modbus TCP service is disabled.
2. Firewall status
Opens a submenu with firewall settings for the this
service for the interfaces
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].