WAGO PFC100 - Host;Domain Name > Domain Name Submenu; Host;Domain Name > Hostname Submenu; Networking > TCP;IP Submenu; Table 121: Networking > Hostname Submenu

176 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.2.4.2 “Host/Domain Name” > “Hostname” Submenu
In this submenu, you can set the hostname of the controller.
Table 121: “Networking” > “Hostname” Submenu
Parameters
Explanation
Enter new Hostname
Enter here the hostname of the controller to be used
if the network interface is changed to a static IP
address or if no hostname is transmitted with a
DHCP response.
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
7.8.2.4.3 “Host/Domain Name” > “Domain Name” Submenu
In this submenu, you can set the domain name of the controller.
Table 122: “Networking” > “Host/Domain Name” > “Domain Name” Submenu
Parameters
Explanation
Enter new Domain Name
Enter the domain name.
The default entry is “localdomain.lan”.
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
7.8.2.4.4 “Networking” > “TCP/IP” Submenu
This submenu contains other submenus with the TCP/IP settings for the
ETHERNET interfaces.
Table 123: “Networking” > “TCP/IP” Submenu
Menu Item
Explanation
0. Back to …
Back to the higher-level menu
1. IP Address
Opens a submenu with settings for the IP
address(es)
2. Default Gateway
Opens a submenu with settings for the default
gateway
3. DNS Server
Opens a submenu with settings for the DNS
server(s)
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].