WAGO PFC100 User Manual

WAGO-I/O-SYSTEM 750 Commissioning 141
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.26 “Configuration of PLC Runtime Services” Page
The settings for various services of the enabled runtime system are shown on the
“Configuration of PLC Runtime Services” page.
7.8.1.26.1 “General Configuration” Group
Table 79: WBM “Configuration of PLC Runtime Services” Page – “General Configuration” Group
Parameters
Explanation
Port Authentication
Password
Enter the new password for port authentication.
Confirm Password
Enter the new password again for confirmation.
Click [Submit] to apply change. The change is effective immediately.
7.8.1.26.2 “e!RUNTIME” Group
Table 80: WBM “Configuration of CODESYS Services” Page – “e!RUNTIME Webserver” Group
Parameters
Explanation
e!RUNTIME State
This displays the status of the e!RUNTIME system
(enabled/disabled).
Webserver enabled
Enable or disable the Webserver for the
e!RUNTIME web visualization.
Port authentication enabled
Enter here whether a login is required for connecting
to the device. The user name is “admin” and the
password is specified under “General
Configuration”.
Click [Submit] to apply change. The change is effective immediately.

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English