WAGO PFC100 User Manual

118 Commissioning WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.11.2 “Firewall Parameters Interface xxx” Group
These settings in this group refer to the configuration of the firewall at IP level.
Table 51: WBM “General Firewall Configuration” Page – “Firewall Parameter Interface xxx” Group
Parameters
Explanation
Firewall enabled for
Interface
Enable or disable the firewall for the specific
interface.
ICMP echo protection
Enable or disable the “ICMP echo” protection for the
respective interface.
ICMP echo limit per second
You can specify the maximum number of “ICMP
echo bursts” per second.
“0” = “Disabled”
ICMP burst limit
You can specify the maximum number of “ICMP
echo bursts” per second.
“0” = “Disabled”
Service enabled
Telnet
Enable or disable the
firewall for the respective
service.
The services themselves
must be enabled or
disabled separately on the
“Ports and Services” page.
FTP
FTPS
HTTP
HTTPS
I/O-CHECK
PLC Runtime
PLC WebVisu –
direct link (port 8080)
SSH
TFTP
BootP/DHCP
DNS
Modbus TCP
Modbus UDP
SNMP
OPC UA
Click [Submit] to apply the change. The change is effective immediately.

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English