WAGO-I/O-SYSTEM 750 Commissioning 159
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.37 “Configuration of OpenVPN and IPsec” Page
The general settings for OpenVPN and IPsec are shown on the “Configuration of
OpenVPN and IPsec” page.
7.8.1.37.1 “OpenVPN” Group
Table 100: WBM “Configuration of OpenVPN and IPsec” Page – “OpenVPN” Group
The current status of the OpenVPN service is
displayed.
Enable or disable the OpenVPN service.
Select an OpenVPN configuration file to be
transferred from PC to controller or vice versa.
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file from the PC to the controller, click [Start Upload]
button.
To transfer the selected file from the controller to the PC, click [Start Download]
button.
The changes only take effect after restarting the controller. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
7.8.1.37.2 “IPsec” Group
Table 101: WBM “Configuration of OpenVPN and IPsec” Page – “IPsec” Group
The current status of the IPsec service is displayed.
Enable or disable the IPsec service.
Select an IPsec configuration file to be transferred
from PC to controller or vice versa.
Select an IPsec configuration file to be transferred
from PC to controller.
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file to the controller, click [Start Upload] button.
To Next Page
Loading...
Need help?
General
