24 Device Description WAGO-I/O-SYSTEM 750
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
3 Device Description
The controller 750-8100(PFC100; 2ETH; ECO) is an automation device that can
perform control tasks of a PLC. It is suitable for mounting on a DIN rail and
stands out on account of its various interfaces.
This controller can be used for applications in mechanical and systems
engineering, in the processing industry and in building technology.
You can connect all available I/O modules of the WAGO-I/O-SYSTEM 750 (750
and 753 Series) to the controller, enabling it to internally process analog and
digital signals from the automation environment, or to supply these signals to
other devices via one of the available interfaces.
Automation tasks can be executed in all IEC 61131-3-compatible languages with
the e!COCKPIT programming system.
The implementation of the task processing in the runtime system for Linux
®
has
been optimized with real-time extensions in order to provide maximum
performance for automation tasks. Web visualization is also provided as
visualization in addition to the development environment.
For IEC-61131-3 programming in CODESYS applications, the controller provides
10 MB of program and data memory (dynamically distributed) and 64 kB of
retentive memory (retain and flag variables) in an integrated NVRAM.
</dg_
Two ETHERNET interfaces and an integrated, interruptible switch enable wiring
for:
• In line topology with a common MAC address and IP address for both
interfaces.
• Two separate networks with a common MAC address and an IP address
for each interface.
Both of these interfaces support:
• 10BASE-T / 100BASE-TX
• Full/Half duplex
• Autonegotiation
• Auto-MDI(X) (automatic uplink and crossover switching)
The following fieldbus circuits are implemented for exchange of process data:
• Modbus TCP Master/Slave
• Modbus UDP Master/Slave
To Next Page
Loading...
Need help?
General
