WAGO PFC100 User Manual

WAGO-I/O-SYSTEM 750 Commissioning 153
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.33 “Configuration of General SNMP Parameters” Page
The general settings for SNMP are given on the “Configuration of General SNMP
Parameters” page.
7.8.1.33.1 “General SNMP Configuration” Group
Table 91: WBM “Configuration of General SNMP Parameters” Page – “General SNMP Configuration”
Group
Parameter
Explanation
Service active
Activate/deactivate the SNMP service.
Name of device
Enter here the device name (sysName).
Description
Enter here the device description (sysDescription).
Physical location
Enter here the location of the device (sysLocation).
Contact
Enter here the email contact address (sysContact).
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English