WAGO PFC100 - Dynamic Routes Group; IP Masquerading Group; Table 48: WBM Routing Page - IP-Masquerading Group

WAGO-I/O-SYSTEM 750 Commissioning 115
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.10.3 “Dynamic Routes” Group
All default gateways received via DHCP are displayed here.
Default gateways configured via DHCP are given the metric value 10, which
means that they are normally used before the statically configured default
gateways.
Each dynamic route has its own area in the display. If no dynamic routes are
received via DHCP, “(no dynamic route)” appears.
7.8.1.10.4 “IP Masquerading” Group
Each entry has its own area in the display.
Table 48: WBM “Routing” Page – “IP-Masquerading” Group
Parameter
Explanation
Enabled
Specify here whether IP masquerading should be
used for the selected network interface.
Disabled
IP masquerading is not used.
Enabled
IP masquerading is used.
Interface
You can select the specified name of a network
interface here. Alternatively, selecting “other” allows
you to specify any network interface name.
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if “Routing enabled entirely” is enabled
in the “General Routing Configuration” group. This allows you to configure a
default setting that is not applied until the general switch-on.