WAGO PFC100 User Manual

WAGO-I/O-SYSTEM 750 Commissioning 113
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.10 “Routing” Page
On the “Routing” page you can find settings and information on the routing
between the network interfaces.
7.8.1.10.1 “General Routing Configuration” Group
Table 46: WBM “Routing” Page – “General Routing Configuration” Group
Parameter
Explanation
Routing enabled entirely
Specify here whether forwarding of IP data packets
is allowed between different network interfaces.
If the box is not checked, the settings under “Static
Routes” are used, without allowing IP data packets
that arrive at the PFC on one network interface to
leave the PFC on different network interface.
If the box is checked, IP packets can be forwarded
between the interfaces.
Other settings may be necessary on this WBM
page.
Click the [Submit] button to apply the change. The changes take effect
immediately.

WAGO PFC100 Specifications

General

Brand	WAGO
Model	PFC100
Category	Controller
Language	English