Describing the autosampler 1-3
Listing component parts
The autosampler’s sampling compartment includes the following parts:
These parts are fitted as standard equipment:
• 100-µL sample loop
• 15-µL injection needle
• 500-µL syringe
• 1000-µL buffer tubing
The instrument uses standard high or low well plates or vial trays. The
sampling compartment can house two well plates in any combination.
Exception: The sampling compartment cannot accommodate 384 short
on the left and 96 tall on the right (see the “Using well plates and vial
trays” section on page 1-24).
Syringe
Needle arm
Injection valve
Valve leak bin
Sample
compartment
Needle wash
position
Wash bottle
To Next Page
Loading...
