SSW7000 | 3-8
3.3. HOW TO SPECIFY THE SSW7000 MODEL (SMART CODE)
In order to specify the correct model of WEG Soft-Starter, use the product smart code. It is composed of
several parts, which are described below:
Table 3.1. Smart Code
SSW7000 A = Panel 070 = 70A T = 2 = up to 2.3kV 11 = 110V 41 = IP41 Blank = Blank = Blank = Blank =
= Soft- Frame 180 = 180A
4 = up to 4.16kV 22 = 220V Standard Standard Standard Global
Starter A 300 = 300A 6 = up to 6.9kV F =
WEG 360 = 360A
series B = Panel 500 = 500A T = 2 = up to 2.3kV 11 = 110V 41 = IP41 Blank = Blank = Blank = Blank =
7000 Frame 600 = 600A
4 = up to 4.16kV 22 = 220V
Standard Standard Standard Global
B
6 = up to 6.9kV
F =
(2 columns)
C = Panel 125 = 125A T = 2 = up to 2.3kV 11 = 110V 54 = IP54 Blank = Blank = Blank = Blank =
Compact 250 = 250A
4 = up to 4.16kV 22 = 220V
Standard Standard Standard Global
359 = 360A 6 = up to 6.9kV F =
D = Panel 180 = 180A T = 9= up to 13,8kV 11 = 110V 41 = IP41 Blank = Blank = Blank = Blank =
Frame 300 = 300A
22 = 220V Standard Standard Standard Global
D
400 = 400A
F =
500 = 500A
(MTW)
600 = 600A
3.4. RECEIVING AND STORAGE
The standard SSW7000 is supplied with the power arms separated from the panel and packed individually.
The SSW7000 panel is supplied in a package composed by cardboard, plastic and wood.
Wood and polystyrene wedges compose the power arm package. There is an identification label outside this
package, which is identical to the one affixed to the power arms. Confront the content of this label with the
purchase order.
The contents of the packages should be verified on product receiving.
NOTES!
If any component is found damaged, it is recommended to:
1. Stop the package opening immediately.
2. Contact the carrier and fill in a format complaint of the problem found.
3. Take pictures of the damaged parts/components.
4. Contact your WEG representative or WEG service.
Guidance for handling, transportation, mechanical and electric installation of the product, is presented in the
chapter 5 - Installation and Connection