SSW7000 | 3-10
Figure 3.11: b) SSW7000C Power Arms with package
3.4.2. Panel and Power Arm Storage
If the panel and/or the power arms are not installed soon after unpacked, the following storage instructions must
be followed:
They must be packed again in their original packages, but without the plastic film, in order to avoid
moisture condensation.
They must be stored in a clean and dry environment (temperature between -25 °C and 50 °C (-13 °F and
122 °F) with moisture below 85 %).
They must be covered up in order to avoid dust accumulation or water splashing.