Weidmüller 610 - Incoming Goods Inspection; Application Notes

52576780000/00/02-2018
Incoming goods inspection
Application notes
Please read these operating instructions and all other publications
that must be consulted in order to work with this product (particu-
larly for installation, operation or maintenance).
Please observe all safety regulations and warnings. Non-compli-
ance with the instructions can lead to personal injury and/or dam-
age to the product.
Any unauthorised alteration or use of this device which exceeds
the specied mechanical, electrical or other operational limits can
cause personal injury and/or damage to the product.
Any such unauthorised alterations are grounds for “abuse” and/or
“negligence” in terms of the product’s guarantee and thus excludes
the warranty for covering any possible resulting damages.
This device must only be operated and maintained by qualied
personnel.
Qualied personnel are persons who, due to their respective train-
ing and experience, are able to recognise risks and avoid potential
hazards that can be caused by operation or maintenance of the
device.
When using the device, the legal and safety regulations required
for the respective application must also be observed.
Safety is no longer guaranteed and the device may be
dangerous if the device is not operated according to the
operating instructions.
All signals connected with the device’s SELV circuit must
also conform with the SELV provisions.
Conductors consisting of single wires must be provided
with ferrules.
Only screw terminals with the same number of poles
and the same type may be plugged together.
About these operating instructions
These operating instructions are part of the product.
• Read the operating instructions prior to using the device.
• Keep the operating instructions at hand throughout the entire
service life of the product and keep ready for referencing.
• Hand over the operating instructions to each subsequent owner
or user of the product.
Incoming goods inspection
The proper and safe operation of this device requires appropri-
ate transport, proper storage, installation and assembly as well as
careful operation and aintenance. When it is assumed that safe
operation is no longer possible, the device must immediately be
taken out of operation and secured against accidental start-up.
Unpacking and packing must be carried out with the usual care,
without the use of force and only with the use of suitable tools. The
devices must be visually inspected for proper mechanical condi-
tion.
It can be assumed that safe operation is no longer possible if the
device, e.g.
• shows visible damage,
• does not work despite intact power supply,
• and was exposed to unfavourable conditions (e.g. storage out-
side of the permissible climatic limits without adaptation to the
ambient climate, condensation, etc.) or transport stresses (e.g.
falling from a great height even without exterior visible damage,
etc.) for prolonged periods.
• Please check that the delivery is complete before you begin with
installation of the device.
All supplied screw terminals are attached to the device.