上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
13 / 36
2. Select Manufacturer permission, search and set the following parameters:
Screw Pitch
It refers to the axial distance between the corresponding points of two adjacent
teeth on the threads.
Its setting should match the actual condition.
Mechanical Reducer Ratio
It refers to the ratio of reducer input speed to output speed.
It consists of parameter Numerator of Mechanical Reducer Ratio and
parameter Denominator of Mechanical Reducer Ratio.
Its setting should match the actual situation.
Mechanical Reducer Ratio
= Reducer Input Speed / Reducer Output Speed
= Teeth No. of Drive Wheel / Teeth No. of Driving Wheel
= Motor Rotational Speed / Screw Rotational Speed
Encoder Digit
Its setting should match the actual situation.
Electronic Gear Ratio
It consists of parameter Numerator of Electronic Gear Ratio and parameter
Denominator of Electronic Gear Ratio.
It refers to the ratio that the servo enlarges or shrinks the received pulse
frequency. If it is greater than 1, the servo enlarges the received pulse
frequency; if it is less than 1, the servo shrinks the received pulse frequency.
Its setting should match the actual situation.
It is set to 1:1 by default.
To Next Page
Loading...
Need help?
General
