上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
22 / 36
3.6 Execute Automatic Machining
This operation is used to start machining.
To execute automatic machining, use one of the following modes:
• Standard machining mode
Automatically execute machining from the beginning to the end.
• Remote machining mode
Automatically execute machining with assembly line of double stations.
3.6.1 Use the Standard Machining Mode
To execute machining in the standard machining mode, click in Auto mode.
The system automatically starts machining.
During machining, you can do the following to control machining:
• To stop machining, click .
• To pause machining, click .
• To resume machining from the exact interrupted position when breakpoint
resume or e-stop occurs, click .
3.6.2 Use the Remote Machining Mode
To execute machining in the remote machining mode, connect port Remote Start on
the terminal board.
After enabling the remote machining mode, the system automatically executes
machining as follows (taking firstly starting machining on the left station as an
example):
To Next Page
Loading...
Need help?
General
