上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
33 / 36
6 FAQs
This section mainly answers common questions that you may encounter during
using Double-tool CNC System.
Common questions can be divided into the following:
• Questions during returning to the machine origin
• Questions about warnings
• Questions about alarms
6.1 Questions during Returning to the Machine Origin
It includes the following common questions that occur during returning to the
machine origin:
• Cannot detect origin signal
• Incorrect axis direction
• Coarse positioning speed is too slow
6.1.1 Cannot Detect Origin Signal
Cause
Error in origin switch.
Solution
1. Touch the origin switch, check and observe related ports in the function
window:
– If they have signals, contact your supplier.
– If they have no signal, proceed to next step.
See Execute I/O Port Related Operations for executing I/O port operations.
2. Check indicator lights of X00, X03, X06, X09 and X12 on the terminal board.
– If they are on, check the electric circuit between the board card and the
terminal board:
• If it loosens, tighten it.
• If it does not loosen, contact your supplier.
– If they are off, check the electric circuit between the origin switch and
terminal board:
• If it loosens, tighten it.
• If it does not loosen, replace the origin switch.
To Next Page
Loading...
Need help?
General
