上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
30 / 36
Cylinder Offset(Y)
The distance between the tool and the height measurement sensor in Y-axis
direction.
Position Z
The machine coordinate of Z-axis before height measurement.
Speed
The moving speed of the measuring device when a height measurement signal
is detected.
3. To start height measurement, select one of the following methods:
– Manually measure height: manually measure height .
– Measure height before cutting: the system automatically measures
height during cutting.
5.2.1 Manually Measure Height
To manually measure height, do the following:
1. In Height Measurement Mode area, select Manually.
2. In Manual mode, move the tool to the target position.
3. Click T1 / T2.
The system starts to measure height.
5.2.2 Measure Height before Cutting
To measure height before cutting, select Before Machining in Height
Measurement Mode area, and click OK.
The system automatically starts to measure height at the start point of the tool path.
If double tools are both active currently, the system measures height for both of
them at the same time.
5.3 Execute Jiggle
This operation is used to adjust height of the tool, so as to find the best cutting
height.
This operation cannot be executed in Idle status. Thus, before executing jiggle,
ensure the system is in Run or Pause status.
To Next Page
Loading...
Need help?
General
