上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
14 / 36
2.5 Adjust the Axis Direction
This operation is used to check if the positive direction of each axis is the same with
the direction stipulated by Right Hand Rule, so as to avoid damage to the machine
tool due to incorrect direction.
Taking X-axis as an example, to adjust the axis direction, do the following:
1. Click System → Global Param, select Manufacturer permission and check
current setting value of parameter Axis Direction (X).
2. Judge the positive direction of X-axis according to the Right Hand Rule.
3. Switch to Manual mode, click X+ or X- button to move X-axis and observe its
moving direction.
4. Optional: If the actual moving direction is opposite to the judged direction,
change the setting value to the opposite value.
Example
Current setting value of parameter Axis Direction (X) is 1. Manually move X-axis
towards the positive direction judged by the Right Hand Rule, and find X-axis
moves towards the negative direction.
Then, you need to change the setting value of parameter Axis Direction (X) to -1.
2.6 Confirm Machine Coordinates of Double Tools
This operation is used to return to the machine origin, confirm the distance between
double tools, and set datum when you use the system at the first time, so as to adjust
coordinate position before machining.
During setting datum, there is no need to set returning order for all axes in datum
setting process, and no need to set datum again after recovering from power
interruption and E-stop because the system will automatically read datum
information.
The double tools share one machine coordinate system.
To Next Page
Loading...
Need help?
General
