1
WEILER E1650 REMIXING TRANSFER VEHICLE
3-12
Operating Instructions
3
Machine Starting Procedure - Cold Start
4. Cycle engine speed (2) to low/idle.
5. Turn Ignition Switch (3) on. If wait to start screen
appears, wait until main screen reappears to start
engine.
6. Press Engine Start Button (4).
7. Run engine at low idle for 2-3 minutes, then increase
engine speed to medium idle until engine reaches
operating temperature. After engine is warmed up,
reduce engine speed to low idle.
NOTICE: Engage various hydraulic systems at lower
engine speeds until hydraulic fluid is warm to avoid
system damage.
To Next Page
Loading...
