1
WEILER E1650 REMIXING TRANSFER VEHICLE
3-6
Operating Instructions
3
Mounting and Dismounting
MOUNTING AND DISMOUNTING
PRE-STARTING INSPECTION (BEFORE EACH USE)
Ensure you understand and comply with all jobsite rules that might apply to your work situation.
Adjust seat for best access to controls.
Ensure mirrors are in good condition, clean, and are adjusted for best visibility.
Verify all control and safety devices function properly.
Inspect machine and ensure that all maintenance items have been performed.
Have all proper PPE necessary for jobsite conditions.
WARNING
Falling hazard.
•Keep ladder, steps, and platform areas clear of objects and debris which
can cause difficulties climbing on or off machine.
•Always face ladder when mounting or dismounting from the platform.
•Mount and dismount machine only where steps and/or handholds are
provided.
•Inspect, and when necessary, clean and have repairs made to steps and
handholds before mounting and dismounting.
•Maintain three-point (two feet and one hand or one foot and two hands)
contact with the steps and handholds.
•Do not jump from ladder, steps, or platform.
•Never get on machine while engine is running or machine is in motion.
•Do not try to climb on or off machine when carrying tools or supplies.
WARNING
Slipping and falling hazard.
Keep walkways, platforms, steps, and ladders clean.
WARNING
Check machine before operating. Machine must be in good operating
condition and all safety equipment installed and functioning properly.
To Next Page
Loading...
