Weiler E1650 - Cleaning and Material Removal

1
WEILER E1650 REMIXING TRANSFER VEHICLE
3-28
Operating Instructions
3
Cleaning or Removing Material
CLEANING OR REMOVING MATERIAL
Dump Hopper Cleanout
The dump hopper (1) is equipped with a full width
cleanout door (2) for access to dump hopper augers and
elevator slats and chain for cleaning and material
removal.
1. Use Manual Elevator Switch (3) to reverse augers
and hopper elevator if dump hopper is empty.
2. If material is in the dump hopper, alternate the
Manual Elevator Switch (3) between reverse and
forward positions to attempt to free the augers and
elevator.
NOTICE: Do not run hopper augers and elevator
continuously in reverse if hopper is nearly full. Auger
and hopper damage may occur if material is forced
against the hopper walls by augers. Alternate the
elevator between reverse and forward to free the stalled
elevator.
3. If elevator and dump hopper augers cannot be
started, raise (4) the elevator/dump hopper
assembly.
4. Securely support the dump hopper/elevator in raised
position with lift locks or use suitable blocking.
NOTICE: To prevent damage to elevator frame, both
sides of dump hopper must be blocked.
WARNING
Augers and conveyor chains and slats can crush or cut. Augers and
conveyors can start unexpectedly when manually removing material from
a stalled elevator.
Stop engine and remove ignition key before manually removing material
from stalled elevator.
2
1
3
4