Welch Allyn VSM 6000 series - Mount the Monitor on a Stand; Mount the Monitor on the Wall; Attach the Probe Well

Note Do not remove the tab label from the battery. This tab helps you
remove the battery from the compartment when you need to
replace it.
5. Replace the battery cover by inserting one end into the notched access and then pressing
firmly on the opposite end.
Note New batteries are only 30 percent charged. Therefore, connect the battery to AC
power immediately after inserting a new a battery.
Mount the monitor on a stand
1. Align the monitor on the black plate in the center of the stand tray.
2. Tighten the screw on the plate into the screw hole on the back of the monitor.
Mount the monitor on the wall
For mounting instructions, see the wall mount manufacturer's directions for use.
Attach the probe well
1. Align the probe well with the tabs facing up and down and insert the probe well into the
temperature module.
18
Setup Welch Allyn Vital Signs Monitor 6000 Series™