Welch Allyn VSM 6000 series - Print Patient Data; Printer; Delete a Patient from the List

Note You can configure some profiles and settings to automatically send
measurements to the network.
Note Patient measurements older than 24 hours are automatically
deleted from the patient records list on the Review tab.
Note The date and time stamps on saved patient measurements will
adjust in response to new date and time settings.
Print patient data
1. Touch Review from the Home tab.
2. Touch next to the names of the patients whose data you want to print.
Once selected, a check mark will be added to the box .
3. Touch Print.
4. Confirm the number of records you want to print and touch OK.
The data is sent to the printer.
Caution Verify patient identity on the monitor after manual or barcode entry and
before printing or transferring patient records.
Printer
The monitor prints to a strip to create printouts of patient information and data.
Note The sample printouts below are English, but the language in the printouts is defined
by the language selected on the monitor.
Continuous monitoring report Spot Check report
Delete a patient from the list
1. Touch the Patients tab.
2. From the List tab, touch the patient record you want to delete.
3. Touch Delete.
Directions for use Patient data management 47