3. Insert the hose connector, pressing firmly until it clicks into place.
Disconnect the NIBP hose
1. Place your thumb and forefinger on the hose connector.
Note Always grasp the hose by the connector. Do not pull on the hose
itself.
2. Squeeze the side tabs until the connector releases.
3. Pull the connector away from the connector port.
Connect the SpO2 cable
WARNING Patient injury risk. Do not use a damaged sensor or pulse oximetry
cable or a sensor with exposed electrical or optical components.
1. Place your thumb and forefinger on the SpO2 cable connector and squeeze the side tabs.
2. Align the cable connector with cable connector port.
3. Insert the cable connector, pressing firmly until it clicks into place.
Disconnect the SpO2 cable
1. Place your thumb and forefinger on the cable connector.
Note Always grasp the cable by the connector. Do not pull on the cable
itself.
2. Squeeze the side tabs until the connector releases.
3. Pull the connector away from the connector port.
Attach an accessory
1. On the rear of the monitor, loosen the screw on the USB door and open it.
2. Attach the accessory's USB cable into an unused USB port on the monitor. The example
below shows how to attach cables for a barcode scanner and a mobile stand light.
Directions for use Setup 21
To Next Page
Loading...
