Alarm messages Priority
Retry temperature measurement. Low
Temperature time limit exceeded. Retry temperature measurement. Low
Low battery; plug into outlet. Low
Printer door is open; close to continue. Low
Printer not functional. Call for service. Low
Out of paper. Low
Printer too hot; wait to retry. Low
Radio not functional. Call for service. Low
Radio error. Power down and restart. Low
Unable to establish network communications. Radio out of network range. Low
Unable to establish network communications. Call for Service. Low
Unable to establish network communications. Call for Service. Low
Radio software upgrade failed. Low
Unable to load configuration; using factory defaults. Low
Functional error. Call for service. Low
External device not recognized. Low
Incompatible Welch Allyn device. Low
USB Communication failure. Low
Nurse call
The monitor can be connected to a Nurse Call system through a cable that connects to the Nurse
Call connector.
When the Nurse Call cable is connected and Nurse Call has been enabled, the monitor
immediately notifies the Nurse Call system when a physiological alarm that exceeds the preset
threshold occurs. The Nurse Call system is also synchronized with the flashing LED lightbar and
audible alerts on the monitor.
Nurse Call thresholds are set in the Advanced Settings.
To connect the monitor to a Nurse Call system, you must have a cable that has been adapted to
your Nurse Call system (REF 6000-NC), rated 25V AC or 60V DC maximum at 1A maximum. For
ordering information, see the VSM 6000 Series Approved Accessories in the Appendix.
56
Alarms Welch Allyn Vital Signs Monitor 6000 Series™
To Next Page
Loading...
