GENERAL WARNINGS
• When disassembling engine, arrange each part
on
a clean surface. Do not mix them
up.
Replace bolts and nuts in their original positions.
• When servicing voltaged parts or connecting instruments to electrical equipment, first
"disconnect negative battery
terminal.
• Replace
gaskets or O-rings with new ones when disassembling, and apply grease on the
0-
ring and the oil seal when reassembling.
•
When exchanging parts, use Universal genuine parts to maintain engine performance and
safety.
•
To
prevent oil and water leakage apply non-drying adhesive to the gasket according to this
manual before reassembling.
•
When hoisting the engine, use the hook provided
on
the cylinder head.
• When installing external circlips or internal circlips, direct corner end to the non-loosening
direction.
Applying grease
to
oil seal
Direction
of
installing circlips
3
2
F-
1
5
1.
Inside
of
Lip
2. Grease
3.
External Circlip
4.
Internal Circlip
5.
Direct the Corner End
to
the Direction Subject
to
Force.
20
4
5
To Next Page
Loading...
