ALTERNATOR
REASSEMBLY
General
DRESS
ROTOR
LEADS
AWAY
FROM PULLER
REMOVING REAR BEARING
The general reassembly instructions are reverse order to the procedures given for disassembly.
Therefore, only information pertaining to special reassembly requirements will
be
covered in this
section.
Install Rear Bearing
Place rotor
on
a press
as
shown in illustration below. Choose a driver sleeve that exerts pressure
on inner race
only and press bearing
on
rotor shaft until it contact shoulder. New replacement
bearings should
be
used whenever bearing is removed during repair procedures or when bearing
is rough, dry or noisy.
BLOCK
REAR
BEARING
RaroR~
\
~
--PRESS
DRIVER
-SLEEVE
INSTALLING REAR BEARING
76
To Next Page
Loading...
