Operation0850−1/A1
Winterthur Gas & Diesel Ltd.
6/ 39
4.3.5 LED Indication on FCM-20 at Start-up
On the right side of the the FCM−20:
After the power is set to on, the SSI CA1, CA2 and CAN S1, S2 and M LEDs show
red for approximately four seconds. The Fail LED shows red for approximately two
seconds. The yellow LEDs In/Out from InjQ to AI3, CAN S1, S2, and M and the green
SW LED then come on.
On the left side of the the FCM−20:
After the power is set to on, the green Power IN LED comes on.
2014
Failures and Defects of WECS Components
To Next Page
Loading...
