EasyManua.ls Logo

WinGD W-X82 - Turbocharging

WinGD W-X82
548 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
65001/A1
Winterthur Gas & Diesel Ltd.
1/ 2
Turbocharging
1. General
The turbocharger is accurately tuned to the engine and related to the number of
cylinders, service output, mode of operation etc. The number of turbochargers is
related to the number of cylinders on the engine.
Data about operation, maintenance and servicing are given in the related
documentation of the manufacturer (which is part of the Operating Instruction).
CAUTION
Damage Hazard: If you operate the engine with a turbocharger cut
out, you must obey the operation limits given in the Service
Bulletin RT-162 to prevent damage to the engine.
2. Function
Exhaust gas (EG) from the cylinders collects in the manifold (10, Fig. 1). The exhaust
gas moves the turbine (12), then flows out through the exhaust gas outlet (EO) to the
exhaust system of the vessel. The exhaust gas turns the turbine (12) and moves the
compressor (11), which is attached to the same shaft. The compressor pulls fresh
air (FA) from the engine room through a filter/silencer.
The compressor compresses and heats the scavenge air (SA). This hot compressed
air flows through air duct (17) into the scavenge air cooler (16), which cools the air to
a lower temperature range. Because of the high humidity in the air, the scavenge air
cooler produces a large quantity of condensation. The water separator (15) removes
the condensation, which flows through the drains (WD) and (CD).
The scavenge air flows from the air space (AS) through the air flaps (13) to the
receiver space (RS) and then into the piston underside (PU).
When the piston (6) is near BDC, charge air flows through the open inlet ports (5) into
the cylinder (3).
After the compression, combustion, and expansion process, the exhaust valve (1)
opens and exhaust gas (EG) flows into the manifold (10), which completes the cycle.
During engine start, or low load operation the auxiliary blowers (7) supply air from the
air space (AS) to the receiver space (RS). The air flaps (13 and 18) prevent a
back-flow of air (see also 64201 Scavenge Air Receiver).
2014

Table of Contents

Related product manuals