Maintenance
3326−2/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 6
3. Removal of crosshaed pin
⇒ Secure the connecting rod with manual ratchets ’H2’ and ’H3’ attached to
RUD-eye bolts ’RC2’ (Fig. ’B’).
⇒ Lift off crosshead pin 4 using manual ratchet ’H4’.
⇒ Carefully swing the connecting rod towards exhaust side by means of manual
ratchets ’H2’ and ’H3’.
⇒ Remove manual ratchet ’H2’ and RUD-eye bolt ’RC2’ on exhaust side before
the connecting rod reaches the column door and lower the upper part onto
wooden underlay ’WU’.
⇒ Install working platform 94142.
⇒ Lower the crosshead as far as possible. Install holders 94325 in the bores of
guide way 11 in the column located on fuel side.
⇒ Secure guide shoes 5, 5a with manual ratchet ’H5’ attached to holder 94325
and eye bolt ’RC3’. Loosen screws 8, detach guide shoes from middle part 6,
6a and remove them from the engine with manual ratchets ’H5’ and ’H1’.
C
EXHAUST SIDE
I
I - I
H1
H5
H4
D
WU
78
6, 6a
5, 5a
II
II
H1
WU
4
RC3
5
94142
10
94325
H3
WCH01035
I
V2 / 2013
Removal and Fitting of a Crosshead Pin
To Next Page
Loading...
