WinGD WARTSILA RT-flex58T-D - Page 303

Maintenance
5552−2/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 11
3. Removal of bearing shells
⇒ Loosen elastic screws 7 to bearings No.
2 3 4
and remove the bearing
covers (Fig. ’C’).
⇒ Place assembly template 94567 on an upper bearing shell (Fig. ’D’).
⇒ Press camshaft 12 accordingly by means of wooden underlay ’HU’ so that the
upper bearing shell can be turned downwards with the assembly template at
the same time (Fig. ’E’).
⇒ Remove the assembly template, the relevant bearing shell and then all other
ones.
Remark: Mark bearing shells after removal!
D
012.982/0
5
012.983/05
I
I
II
II
I
I
X
94567
HU
I - I
II-II
7
17
94567
E
12
Supply Unit: Removal and Fitting of Camshaft and Bearing Shells
V2 / 2013