Maintenance
9403−1/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
1/ 1
1. General
The tools required for erection and maintenance of the engine are divided into
three groups as per the following ’Tool List’:
− Standard tools
− Recommended special tools
− Special tools available on loan
When ordering additional tools or replacements, the tool No. as well as the tool
description including engine type must be indicated (see 9403−5).
Detailed instructions on the arrangement and application, storing, servicing and
maintenance of the hydraulic pre-tensioning jacks are given in 9403−2 to 9403−4.
When oil must be added to the hydraulic pumps, the specification regarding oil
quality issued by the pump manufacturers must be followed. Utilize generally an
engine lub. oil having viscosities SAE 30 to SAE 40.
A cylinder lubricating oil also can be used in exceptional cases.
A separate set of tools is issued for certain components from sub-suppliers, which
should also be stored separately from the engine tools.
2. Standard tools
... are tools and devices required for normal maintenance work on the engine. In
this respect take into consideration that, depending on the design execution of the
engine, certain tools and devices which are mentioned in the above sheets are not
required for specific maintenance work, and are therefore not part of the engine
tools supply.
3. Recommended special tools
... are tools and devices, which allow certain maintenance work to be done with
more ease, and in a shorter time, than with the standard tools.
These tools can be ordered separately either with the engine or at a later date.
4. Special tools available on loan
... are such tools and devices which are loaned for transportation and for erection
of the engine. They are to be returned to the engine manufacturer after completion
of engine erection.
Tools
Explanation
2013
To Next Page
Loading...
Need help?
General
