Wittenstein cyber motor simco SIM2002D - Ambient Conditions; Requirements for Cables and Wiring; STO Safety Function; 4 Transport and Storage

Operation Manual simco
®
drive
Revision: 11a 4022-D033499 en-11
deutsch
english
français
italiano
español
日本語
3.4.4 Ambient conditions
− Ambient temperature during operation: 0 .. 45 °C for nominal data, in order to meet
the UL conformity, the ambient temperature during operation must not exceed
40 ° C
− Air humidity during operation: Relative humidity < 85%, non-condensing
− Installation altitude: < 1000 m above sea level without affecting performance
− Type of protection: IP65 or IP20 in accordance with EN60529, depending on the
product
− For IP20 version, the following applies: Degree of pollution 2 to EN 60204 / EN
50178
3.5 Requirements for cables and wiring
• In general, use high-quality, shielded motor and encoder cables to avoid EMC
problems.
Wire type
Maximum length
Capacitance
Core to shield
Motor wire
20 m
< 150 pF/m
Encoder line
20 m
< 120 pF/m
Resolver line
20 m
< 120 pF/m
Further requirements regarding UL conformity are listed in chapter 2.1.2.
3.6 STO safety function
The STO safety function (Safe Torque Off) is used for safe torque shutdown and to reliably
protect drives from restarting. The drive amplifier is fitted with a two-channel STO function
as standard in the basic model.
i Instructions for the STO safety function can be found in the appendix (see Chapter 10
"Instructions for STO safety function").
4 Transport and storage
4.1 Transport
− Transportation only in original packaging by qualified personnel
− Avoid hard impacts and vibrations
− Transport temperature: -20 .. 60 °C, max. 20 K/hour fluctuation
− Transport air humidity: Relative humidity max. 95%, non-condensing
− If the packaging is damaged, check the drive amplifier for visible damage. Contact the
responsible shipping company
The drive amplifier contains components that are sensitive to
electrostatic charge and can be damaged when handled
improp
erly.
•
Ensure proper ESD handling by qualified personnel.
4.2 Packaging
− ESD-compatible box
− Identification: Label attached to the outside of the box
4.3 Storage
− Storage only in ESD-compatible original packaging
− Storage temperature: -20 .. 50 °C, max. 20 K/hour fluctuation
− Air humidity: Relative humidity max. 95%, non-condensing