Wolf RM-2 - Installation and Electrical Connection; Mounting and Wall Retainer Installation

Installation and electrical connection
10 | WOLF GmbH 3066510_202108
3 Installation and electrical connection
The module must be xed to the wall using the wall retainer. It can be
placed directly on the wall or on a ush-mounting box.
3.1 Installation recommendations
– Install the module on an internal wall approximately 1.5 m above
the oor.
– In order for the room temperature sensor to function properly, the
module must be installed in a representative room.
– The RM-2 Wireless can also be placed within a room as a mobile
unit.
– The module must not be obstructed by furniture or curtains.
– Do not install the module next to a heat source.
– All radiator valves must be fully opened in this room.
– Keep the module out of direct sunlight and UV radiation.
3.2 Installing the wall retainer
The wall retainer is tted to the wall or the ush-mounting box
using the two included screws and rawl plugs (hand-tight with a
screwdriver).
i
Feed the cable through the entry point before installing
the wall retainer.
q
Fig. 3.1 Wall retainer
q Cable entry (eBus or 9 VDC power supply unit)